MTD 464 Betriebsanleitung PDF herunterladen (Seite 476)

ARMY TM 9-6115-464-34

AIR FORCE TO 35C2-3-445-2

NAVY NAVFAC P-8-624-34

(28) Attach lifting sling to roof panel assembly, and position on generator set. Ensure alignment pins are

in holes. It may be necessary to use C-clamps to pull the side panels into position using the lifting

clevis as an anchor for the C-clamp. Remove plastic plugs from rotolock holes. Align male and

female rotolocks and, using hex tool, turn rotolocks to secure the roof panel assembly. Remove the

lifting sling. (Refer to figure 5-37.) Install plastic plugs. Install two socket head capscrews to secure

roof panel assembly.

(29) Slide sealing angle into position, and tighten capscrews.

(30) Tighten capscrews securing mounting members.

(31) Attach lifting sling to inlet turn assembly, and position on roof assembly. Remove the lifting sling.

Remove plastic plugs from rotolock holes. Align male and female rotolocks and, using hex tool, turn

rotolocks to secure the inlet turn assembly. (Refer to figure 5-37.) Install plastic plugs.

(32) Attach lifting sling to discharge turn assembly, and position on roof assembly. Remove the lifting

sling. Remove plastic plugs from rotolock holes. Align male and female rotolocks and, using hex tool,

turn rotolocks to secure the discharge turn assembly. (Refer to figure 5-37.) Install plastic plugs.

NOTE

Keepers, washers, and capscrews must be moved to end panels to secure side panel skirts.

(33) Position upper side panel skirt on side panels and install screws, keepers, washers, and capscrews.

(34) Install side panel skirts on slip-joint hinge and secure with keepers.

(35) Lower side panel skirts.

(36) Ensure inlet door, discharge door, control panel access door, and access doors are closed.

(37) Reconnect battery cables.

NOTE

When bottom panel tray assembly is installed, generator set will require one inch

clearance. Stones, debris, or other material may damage bottom tray assembly.

Generator set may not be skidded with bottom panel tray installed.

c. Remove acoustic suppression kit from generator set by reversing installation procedures.

d. If generator set is to be trailer mounted, the following must be performed.

(1) Raise side panel skirts, and install ground wire. Install anti-rotation clips and fiber washers on

capscrews, and install capscrews. Lower side panel skirts.

(2) Glue isolators on skid base or surface of trailer. (Refer to figure 5-34.)

(3) Lower generator set onto trailer. Attach ground wire to trailer.

(4) Install washers and nuts on capscrews to secure generator set.

NOTE

Do not overtighten nuts. Tighten to 5 ft-lb torque (6.80 Nm). Install jam nuts.

(5) Remove hex nuts, capscrews, and locking pins from trailer platform.

(6) Position trailer brackets, and install capscrews, hex nuts, and locking pins on trailer brackets.

5-74

1 2 ... 471 472 473 474 475 476 477 478 479 480 481 ... 492 493

MTD 464 Betriebsanleitung Seite 476