MTD 464 Betriebsanleitung PDF herunterladen (Seite 475)

ARMY TM 9-6115464-34

AIR FORCE TO 35C2-3-445-2

NAVY NAVFAC P-8-624-34

(18)

(19)

(20)

(21)

(22)

(23)

(24)

(25)

(26)

(27)

Install keepers, washers, and capscrews to secure the bottom tray assembly. (Refer to figure 5-34.)

Raise generator set, and remove 1“x4” block. Lower generator set and remove lifting device.

CAUTION

Do not allow side panel to fall from mounting members or set side panels on threaded

studs. Failure to observe this caution could result in equipment damage.

Raise side panel skirt 90° and remove from side panel assembly. Remove screws, capscrews,

washers, keepers, and remove upper side panel skirt. (Refer to figure 5-37.) Attach lifting sling, and

carefully raise and position side panel assembly on mounting member.

Install three rubber washers, three flatwashers, and three locking nuts supplied with kit in bottom of

side panel. Ensure rubber flaps are flat against radiator and are pointed forward. Remove plastic

plug and feed oil drain hose through side panel hole. (Refer to figure 5-36.)

Remove lifting sling from side panel.

Repeat steps (20) thru (22) to install other side panel.

CAUTION

Do not allow front lower panel to drop or set on ground.

result if caution is not observed.

Damage to brackets could

Position front lower panel assembly on generator set. Ensure top rubber flap is in raised position on

radiator shell lip. Remove plastic plugs from rotolock holes. Align male and female rotolocks and,

using hex tool, turn rotolocks to secure the front lower panel assembly. (Refer to figure 5-37.) Install

plastic plugs. Ensure mounting zee is below bottom tray assembly.

Attach lifting strap to front top panel, and raise front top panel assembly on side panels. Ensure

alignment pins fit in holes for proper alignment. Remove plastic plugs from rotolock holes. Align male

and female rotolocks and, using hex tool, turn rotolock to secure the front top panel assembly.

Remove lifting strap. (Refer to figure 5-37.) Install plastic plugs.

Position exhaust extension on engine exhaust. Install and tighten clamp to secure the exhaust

extension. Exhaust extension opening must be pointed down and must not interfere with other

components later.

CAUTION

Do not allow rear panel assembly to drop or set on ground. Damage to brackets could

result if caution is not observed.

Attach lifting strap on rear panel assembly, and position rear panel assembly on generator set.

Ensure alignment pins are in holes for proper alignment. Remove plastic plugs from rotolock holes.

Align male and female rotolocks and, using hex tool, turn rotolocks to secure the rear panel

assembly. Remove lifting strap. (Refer to figure 5-37.) Install plastic plugs. Ensure mounting zee is

below bottom tray assembly.

NOTE

Ensure lifting clevises are in the raised position before installing the roof panel assembly.

5-73

1 2 ... 470 471 472 473 474 475 476 477 478 479 480 ... 492 493

Kommentare zu diesen Handbüchern

Keine Kommentare

MTD 464 Betriebsanleitung Seite 475

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gartenschredder MTD 464