MTD 464 Betriebsanleitung PDF herunterladen (Seite 388)

ARMY TM 9-6115-464-34

AIR FORCE TO 35C2-445-2

NAVY NAVFAC P-8-624-34

c. Procedure.

(1) Preparation for test.

(a)

(b)

Connect the load and field instrumentation in accordance with the applicable figure of

MIL-HDBK-705, Method 205.1, paragraphs 205.1.10, for one voltage and frequency. Connect the

signal input of the recording meter(s) to the convenience receptacle of the set or to the generator

coil which is used as the voltage sensing input to the voltage regulator. (Power the recording

meter(s) from the commercial utility.)

Set the recording meter chart speed(s) to a minimum of 5 inches per hour. The following items shall

be recorded on both the data sheets and recording chart(s):

1. The date

2. The serial number(s) of the recording meter(s)

3. Generator set identification

4. The recording chart speed(s)

5. The data reading number

(2) Test.

(a) Start and operate the generator set and allow the set to stabilize at rated load, rated voltage and

rated frequency. During this period operate the recording meter(s) at a chart speed of not less than

6 inches per hour, and record all instrument readings including thermal instrumentation at minimum

intervals of 10 minutes. If necessary, adjustments to the load, voltage and frequency may be made

to maintain rated load at rated voltage and frequency. Adjustments to the voltage and frequency

shall be limited to those adjustments available to the operator, specifically adjustments to the

voltage or frequency adjust devices. On sets utilizing a droop-type speed control droop portions of

the control may be adjusted. No other adjustments to the voltage and frequency control systems

shall be made. Adjustments to load, voltage or frequency controls shall be recorded on both the

data sheet and the recording chart(s) at the time of an adjustment. Stabilization shall be considered

to have occurred when four consecutive voltage and current recorded readings of the generator (or

exciter) field either remain unchanged or have only minor variations about an equilibrium condition

with no evident continued increase or decrease in value after the last adjustment to the load,

voltage or frequency has been made.

(b) After stabilization has occurred, drop the load to no load and reapply rated load a number of times

(three should be sufficient) to assure that the no load and rated load voltage and frequency values

are repeatable and that the frequency and voltage regulation is within the limits specified in the

procurement document. If any adjustments are necessary, paragraph (a) above must be repeated.

Reapply rated load.

4-11

1 2 ... 383 384 385 386 387 388 389 390 391 392 393 ... 492 493

MTD 464 Betriebsanleitung Seite 388