MTD 464 Betriebsanleitung PDF herunterladen (Seite 50)

ARMY TM 9-6115-464-34

AIR FORCE 35C2-3-445-2

NAVY NAVFAC P-8-624-34

(i) lf winterization kits are installed, tag and disconnect electrical Ieads to engine sensors and

(2)

(3)

(4)

(5)

(6)

(7)

(8)

(9)

disconnect coolant lines from engine oil pan.

CAUTION

Do not use a lifting device of less than 1000 lb. capacity. Failure to observe this caution

could result in damage to the equipment.

Attach a suitable lifting device to engine lifting brackets.

Disconnect engine crankcase oil drain tube from fitting in skid base.

Remove screw (1, figure 2-1), Iockwasher (2), and access cover (3).

Remove screws (4), Iockwashers (5) and air inlet screen (6).

Remove screws (7) and lockwashers (8), Iockplate (9) and pressure plate (10).

CAUTION

Take slack from hoisting sling prior to loosening generator and engine coupling bolts.

Failure to observe this caution could result in damage to the equipment .

Remove screws (11) and Iockwasher (12).

Remove bolts (13) and Iockwashers (14).

CAUTION

Make a final, thorough check to ascertain that the engine is completely disconnected

from the generator set prior to attempting to hoist it clear. Failure to observe this

caution could result in damage to the equipment.

Carefully move the engine up and forward until generator coupling disc clears engine flywheel

housing.

CAUTION

Do not use a lifting device of less than 1000 lb. capacity. Failure to observe this

caution could result in damage to the equipment.

b. Installation.

(1) To install engine, use a suitable lifting device to lift engine by the hooks located on the engine.

(2) Carefully lower the engine (15, figure 2-1) until generator coupling and engine flywheel housing

alignment matches.

(3) .Alignment pins with 5/8 inch headless bolt should be screwed into holes in the flywheel to facilitate

alignment.

(4) Tighten down engine bolts Iecated in front of the engine to secure alignment. Torque according to

paragraph 1-10y

(5) Install Iockwashers (14), and bolts (13).

(6) Install Iockwashers (12), and screws (11).

(7) Install pressure plate (10), Iockplate (9), Iockwashers (8), and screws (7).

(8) Install air inlet screen (6), Iockwashers (5), and screws (4).

2-16

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 492 493

MTD 464 Betriebsanleitung Seite 50

Kommentare zu diesen Handbüchern

MTD 464 Betriebsanleitung Seite 50

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gartenschredder MTD 464