MTD E600E Betreibershandbuch PDF herunterladen (Seite 16)

600/610E has only one auger belt).

Remove the plastic belt cover on the front of the

engine by removing the two self-tapping screws.

See Figure 22.

Belt

/ Cover

Figure 22

Drain the gasoline from the snow thrower, or place

a piece of plastic under the gas cap.

Tip the snow thrower up and forward so that it rests

on the housing.

Remove six self-tapping screws from the frame

cover underneath the snow thrower.

Roll the front and rear auger belts offthe engine

pulley. See Figure 23.

Rear Auger t_ _'_ -- _ Drive ]

Belt \ ,-- _ (f==_ Belt Engine I

/Pu.ey I

_/ (/_'_ _;;;_--_ Front AugerI

Idler _ l'_*J_',,_ _ _//Belt I

Pulley \ _f %,.'_ _ JF I

/ Engine Pulley \K ._ I

/ Pulley \_.L_ _- J

Figure 23

Unhook the idler spring from the hex bolt on the

auger housing. See Figure 24.

Back out the stop bolt to allow the belts to slip

between the bolt and auger pulley. See Figure 25.

NOTE: It may be necessary to loosen the six hex nuts

that fasten the frame to the auger housing to aid in belt

removal.

Friction

Wheel

Support

Rear Auger

Belt --

Front Auger

Pulley Auger Auger Bracket

Pulley Idler Housing Spring

Spring

Figure 24

Liftthe rear auger belt from the auger pulley, and

slip belt between the support bracket and the auger

pulley. See Figure 24. Repeat this step for front

auger belt (except models 600/610E).

Replace both auger drive belts by following

instructions in reverse order.

DriveBelt

Follow steps 1 through 4 of previous instructions.

Pull idler pulley up, and lift belt off engine pulley

and friction wheel disc. See Figure 23.

Back out the stop bolt untilthe support bracket

rests on the auger pulley. See Figure 25.

Slip belt between friction wheel and friction wheel

disc. Remove and replace belt. Reassemble

following the instructionsin reverse order.

NOTE: The support bracket must rest on the stop bolt

after the new belt has been assembled. See Figure 25.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

MTD E600E Betreibershandbuch Seite 16

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Schneewerfer MTD E600E