MTD E600E Betreibershandbuch PDF herunterladen (Seite 14)

underneaththesnowthrowerbyremovingsixself-

tappingscrews.

Withthetractioncontrolreleased,theremustbe

clearancebetweenthefrictionwheelandthedrive

plateinallpositionsoftheshiftlever.Withthetraction

controlengaged,thefrictionwheelmustcontactthe

driveplate.SeeFigure18.

Friction

WheelI LI

_ _ PI_ /f_ Gear Shaft I

Figure 18

If adjustment is necessary, loosen the hex jam nut on

the traction control cable and thread the cable inor

out as necessary. Tighten the hex jam nut to secure

the cable when correct adjustment is reached.

Reassemble the frame cover.

NOTE: If you placed plastic under the gas cap, be

certain to remove it.

DriveWheels

The wheels may be adjusted for two different

methods of operation. The adjustment is made by

placing the klick pins in one of two different holes on

the right side of the unit. See Figure 19.

One Wheel Driving- Place ktick pin in the outside

axle hole on the right side. This position gives

power drive to the left wheel only, making the unit

easier to maneuver.

Both Wheels Driving- Rotate wheel assembly to

align hole in hub with inner hole on axle shaft.

Insert klick pin in hole. Outer axle shaft hole

should be visible. This position is good for heavy

snow as there is power to both wheels.

Hub Hole

Pin In

Outside Axle

Hole

Figure 19

SECTION7: MAINTAININGYOURSNOWTHROWER

_lb WARNING: Before servicing, repairing,

or inspecting, disengage all clutch levers

and stop engine. Wait until all moving parts

have come to a complete stop. Disconnect

spark plug wire and ground it against the

engine to prevent unintended starting.

Lubrication

ChuteDirectionalControl

The worm gear on the chute directional control should

be greased with multipurpose automotive grease.

Wheels

Oil or spray lubricant into bearings at least once a

season. Pull the klick pins and remove wheels, clean

and coat axles with a multipurpose automotive

grease. See Figure 20.

_/Klick Pin

Axle

Figure 20

AugerShaft

At least once a season, remove shear bolts on auger

shaft. Oil or spray lubricant inside shaft. Also lubricate

the auger bearings at least once a season. See

Figure 21.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

MTD E600E Betreibershandbuch Seite 14

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Schneewerfer MTD E600E