MTD E600E Betreibershandbuch PDF herunterladen (Seite 13)

ToEngageAugers

To engage the augers and start the snow throwing

action, squeeze the auger control against the left

handle. Release to stop the augers.

TireChains(OptionalEquipment)

If your unit is not equipped with tire chains, you may

purchase them. Tire chains should be used whenever

extra traction is needed.

OperatingTips

NOTE: Allow the engine to warm up for a few

minutes as the engine will not develop full power until

it reaches operating temperature.

_lb WARNING: Muffler, engine and

surrounding areas become hot and can

cause a burn. Do not touch.

For most efficient snow removal, remove snow

immediately after it falls.

Discharge snow downwind whenever possible.

Slightly overlap each previous path.

Set the skid shoes 1/4" below the scraper bar for

normal usage. The skid shoes may be adjusted

upward for hard-packed snow. Adjust downward

when using on gravel or crushed rock.

Be certain to follow the precautions listed under

STOPPING ENGINE to prevent possible freeze-

up.

Clean the snow thrower thoroughly after each

use.

SECTION6: MAKINGADJUSTMENTS

WARNING: NEVER attempt to make

any adjustments while the engine is

running, except where specified in the

operator's manual.

ChuteAssemblyAdjustment

The distance snow is thrown can be adjusted by

adjusting the angle of the chute assembly. The

sharper the angle, the shorter the distance snow is

thrown. See Figure 17.

To adjust chute assembly, loosen the hand knob.

Pivot the top of the chute assembly to position

desired. Retighten the hand knob.

ShiftRodAdjustment

To adjust the shift rod, separate the shift rod and

ferrule from the shift lever by removing the hairpin clip

and flat washer from the ferrule underneath the

handle panel. Refer to Figure 9. Adjust as specified in

the Assembly Instructions.

CarburetorAdjustment

WARNING: If any adjustments need to

be made to the engine while the engine is

running (e.g. carburetor), keep clear of all

moving parts. Be careful of muffler, engine

and other surrounding heated surfaces.

Minor carburetor adjustment may be required to

compensate for differences in fuel, temperature,

altitude and load.

Refer to the separate engine manual packed with

your unit for carburetor adjustment information.

SkidShoeAdjustment

The space between the shave plate and the ground

can be adjusted. Refer to the ASSEMBLY section.

Figure 17

AugerClutchAdjustment

To adjust the auger control, refer to FINAL

ADJUSTMENT section of Assembly Instructions.

TractionControlAdjustment

Refer to the FINAL ADJUSTMENT section of the

Assembly Instructions to adjust the traction control. If

you are uncertain that you have reached the correct

adjustment, the adjustment can be physically

checked as follows.

With the snow thrower tipped forward (be certain to

drain the oil and gasoline or drain the oil and place

plastic film under the gas cap if the snow thrower has

already been operated), remove the frame cover

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

MTD E600E Betreibershandbuch Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Schneewerfer MTD E600E