MTD 464 Betriebsanleitung PDF herunterladen (Seite 423)

ARMY TM 9-6115-464-34

AIR FORCE TO 35C2-3-445-2

NAVY NAVFAC P-8-624-34

5-9. HEATER CONTROL ASSEMBLY.

a. Removal. Refer to the Operator and Unit Maintenance Manual for heater control assembly removal

instructions.

b.Disassembly.

(1)

(2)

(3)

(4)

(5)

(6)

(7)

(8)

(9)

(10)

(11)

(12)

(13)

(14)

NOTE

Disassemble heater control assembly only as required to clean, inspect, test and

replace components.

Tag all electrical leads before disconnecting.

Remove screws (1, figure 5-7), Iockwashers (2), and pull the panel (22) away from the Chassis (60),

as far as electrical connections will allow.

Remove nut (3), tooth Iockwasher (4), positioning washer (5), nut (6) and switch (7).

Remove nut (8), tooth Iockwasher (9), and circuit breaker (10).

Remove fuseholder (11), fuse (12), nut (13), tooth Iockwasher (14) and fuse holder (15).

Remove lens (16), lamp (17), nut (18), indicator light base (19), nut (20), tooth Iockwasher (21).

Remove screw and captive washer assembly (23) and cover (24).

Remove screw and captive washer assembly (25), nut and captive washer assembly (26), screw and

captive washer assemblies (27 and 28) and cushion clamp (29).

Remove nut (30), flat washer (31), tooth Iockwasher (32), and semiconductor (33).

Remove nut (34), flatwasher (35), Iockwasher (36) and semiconductor (37).

Remove nut (38), flat washer (39), shoulder washer (40), screw & captive washer assembly (41),

heat sink (42), shoulder washer (43), split grommet (44) and heat sink bracket (45).

Remove screw and captive washer assembly (46), protective cap and chain (47), nut (48), screw and

captive washer assembly (49), nut (50), and wiring harness (51).

Remove nut (52), shoulder washer (53), screw (54), power relay (55) and relaly insulator (56).

Remove nut (57), screw and captive washer assembly (58), and transformer (59), from chassis (60).

c. Cleaning. Inspection, and Repair.

WARNING

Compressed air used for cleaning and drying purpcses can create airborne particles

that may enter the eyes. Pressure shall not exceed 30 psig and use only with adequate

chip guards and chipping goggles. Failure to observe this warning could result in

servere personal injury or death.

WARNING

Solvent, Dry Cleaning P-D-680, Type II is flammable and moderately toxic to skin,

eyes and respiratory tract. Eyes and skin protection required. Good general ventilation

is normally adequate. Failure to observe this warning could result in servere personal

injury or death.

5-20

1 2 ... 418 419 420 421 422 423 424 425 426 427 428 ... 492 493

MTD 464 Betriebsanleitung Seite 423

Kommentare zu diesen Handbüchern

MTD 464 Betriebsanleitung Seite 423

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gartenschredder MTD 464