MTD 464 Betriebsanleitung PDF herunterladen (Seite 166)

ARMY TM 9-6115-464-34

AIR FORCE 35C2-3-445-2

NAVY NAVFAC P-8-624-34

c. Cleaning, Inspection, and Repair.

WARNING

Solvent, Dry Cleaning P-D-680, Type II is flammable and moderately toxic to skin,

eyes and respiratory tract. Eye and skin protection required. Good general ventilation

is normally adequate. Failure to obsever this warning could cause servere personal

injury or death.

(1)

(2)

(3)

(4)

(5)

(6)

(7)

(8)

(9)

WARNING

Compressed air used for cleaning and drying purposes can create airborne particles

that may enter the eyes. Pressure shall not exceed 30 psig and use only with adequate

chip guards and chipping goggles.

Failure to obsever this warning could cause

servere personal injury or death.

Clean all parts in dry cleaning solvent (Federal Specification P-D-680) and dry thoroughly with

filtered compressed air.

Scrape carbon deposits from valves and cylinder head.

Visually inspect rocker arms for cracks, corrosion, and excessive wear. Check that oil holes are

open.

Inspect rocker arm shafts for cracks, deep wear patterns, nicks, and burrs. Remove minor nicks and

burrs with oil soaked crocus cloth. Clean polished shaft in dry cleaning solvent to remove abrasive

particles.

Inspect blocks for cracks, nicks, burrs, and excessive wear. Remove nicks and burrs from outer

surfaces with fine abrasive paper or stone.

Inspect springs for cracks, breaks, chaffing and distortion.

Inspect push rods for cracks, bends, excessive wear, nicks and scratches. Polish push rods with

crocus cloth to remove minor defects.

Inspect valve guides for excessive wear. Bore diameter of exhaust valve guide shall be 0.3750 to

0.3790 inch. Bore diameter of intake valve guide shall be 0.3740 to O. 3780 inch.

Replace worn valve guides as follows:

(a) Use a 5/8 inch drift with a 3/8 inch pilot and drive out valve guides.

(b) Drive replacement valve guides to a depth of 1.3700 to 1.3800 inches blow cylinder head deck.

(d) Ream bore diameter of exhaust valve guides to 0.3750 to 0.3760 inch.

(10)

(11)

(12)

Inspect valve springs for cracks, breaks, and distortion. Using a spring tester, compress valve spring

to a length of 1.4920 inches. Test load shall be 72 to 82 pounds. Compress spring to a length of

1.0820 inches. Test load shall be 80 to 86 pounds.

Inspect cylinder head for cracks, breaks, and broken studs. Remove broken studs by center

punching, drilling, and using an easy out.

Check cylinder head for warping using a straightedge and feeler gauge. Check lengthwise and

between each cylinder crosswise. Warpage shall not exceed 0.003 inch laterally and 0.005 inch

longitudinally. Cylinder head may be milled to remove minor warpage.

3-112

1 2 ... 161 162 163 164 165 166 167 168 169 170 171 ... 492 493

MTD 464 Betriebsanleitung Seite 166

Kommentare zu diesen Handbüchern

MTD 464 Betriebsanleitung Seite 166

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gartenschredder MTD 464