MTD 464 Betriebsanleitung PDF herunterladen (Seite 155)

ARMY TM 9-6115-464-34

AIR FORCE TO 35C2-3-445-2

NAVY NAVFAC P-8-624-34

h. The connecting rods are heavy alloy steel forgings with precision type bearings for the crankshaft and

bronze bushings for the full floating piston pin. The pistons are made of aluminum and are the solid type (no

saw slots or splits in the skirt). Each piston is fitted with five rings. The top three rings are compression type and

the fourth ring from the top is an oil control ring. The fifth ring is an oil scrapper ring.

i. The cylinder block and crankcase are cast as a single unit giving ridged support for the crankshaft. Cooling

is obtained by water jacketing the entire length of the block. When installed in the generator set, the block is

supported by the front engine support with rear support supplied through ridged coupling to the generator

assembly housing.

3-49. ENGINE FRONT SUPPORT.

a. Removal.

NOTE

If engine is not removed from the generator set, block the front of the engine prior to

removing the front engine support.

(1) Remove nut (1, figure 3-41), Iockwasher (2), ring (3), and crankshaft (4).

(2) Remove front engine support from crankshaft by removing bolt and Iockwasher.

b. Cleaning, Inspection, and Repair.

WARNING

Solvent, Dry Cleaning P-D-880, Type H is flammable and moderately toxic to skin,

eyes and respiratory tract. Eye and skin protection required. Good general ventilation

is normally adequate. Failure to observe this warning could result in servere personal

injury or death.

(1)

(2)

(3)

(4)

(5)

(6)

WARNING

Compressed air used for cleaning and drying purposes can create airborne particles

that may enter the eyes. Pressure shall not exceed 30 psig and use only with adequate

chip guards and chipping goggles.

Failure to observe this warning could result in

servere personal injury or death.

Clean all parts in a dry cleaning solvent (Federal Specification P-D-880) and dry thoroughly with

filtered compressed air. Remove caked grease deposits with a stiff bristle brush.

Inspect engine front support for cracks, corrosion, and excessive wear. Check inner surfaces for

scores, ridging, and other damage.

Check crankshaft pulley for corrosion, cracks, and step wear in v-belt groove.

Check all threads for crossing, stripping, and peening.

Repair minor thread damage with a thread chaser.

Replace any parts damaged beyond repair.

c. Installation.

(1) Install lockwasher (7, figure 3-41), bolt (6), to crankshaft to install engine front support (5)

(2) Install crankshaft (4), ring (3), Iockwaser (2) and nut (1).

3-101

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 492 493

MTD 464 Betriebsanleitung Seite 155

Kommentare zu diesen Handbüchern

MTD 464 Betriebsanleitung Seite 155

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gartenschredder MTD 464