MTD 464 Betriebsanleitung PDF herunterladen (Seite 151)

100

101

ARMY TM 9-6115-464-34

AIR FORCE TO 35C2-3-445-2

NAVY NAVFAC P-8-624-34

(c)

(d)

(e)

(f)

Move the piston gradually towards the fully closed throttle position. The transducer secondary

voltage, indicated by meter M1 shall increase in a linear manner to a maximum of 48 to 55 volts.

Repeat these adjustments until the transducer secondary voltage increases linearly from the lowest

possible value to a maximum value over the entire 1.0 inch displacement of the piston.

When final adjustment is made lock the transducer core in place with the transducer core set

screw.

Remove the gages, meter, and power supplies.

9. Installation and Final Adjustment.

(1) Position actuator unit (14, figure 3-36) to install Iockwashers (13), and bolts (12).

(2) If removed, install threaded rod (11), locknut (10), rod ends (9), screws (8) and nut (7)

(3) Install bolt (6) and nut (5).

(4) Connect hydraulic lines (4 and 3) and electrical connectors (2 and 1).

(5) Refer to the Operator and Unit Maintenance Manual and fill the hydraulic tank.

NOTE

Leave governor linkage loose to accommodate adjustments.

(6) Place the generator set START-RUN- STOP switch in the RUN position.

CAUTION

Do not attempt to start the generator set. Failure to observe this caution could result in

equipment damage.

(7) Place the generator set BATTLE SHORT switch in the override (ON) position.

(8) Beginning at the full counterclockwise position, rotate the fuel injection pump shutoff lever in the

clockwise direction until a slight resistance is felt. Hold the shutoff lever in this position.

NOTE

This resistance is the fuel injection pump governor linkage hook engaging the metering

valve arm.

(9) Move the hydraulic actuator unit piston to the extended position for 69-600-3, retracted position for

69-600-2 (refer to table 3-2).

(10) Adjust the hydraulic actuator governor linkage until it fits between the actuator unit piston clevis and

the fuel injection pump shutoff lever.

(11) Return the generator set START-RUN-STOP switch to the STOP position and the BATTLE SHORT

switch to the OFF position.

3-97

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 492 493

MTD 464 Betriebsanleitung Seite 151

Kommentare zu diesen Handbüchern

MTD 464 Betriebsanleitung Seite 151

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gartenschredder MTD 464