MTD 27-Ton Wartungshandbuch PDF herunterladen (Seite 61)

Tank and Tires

Oil filter housing

To remove/replace the oil filter housing:

1. With the engine turned-off, relieve hydraulic pressure

from the system by moving the lever on the control

valve through it’s full range of travel.

2. Place a suitable container under the oil filter to catch

any fluid that will spill.

See Figure 7.12.

3. Remove the oil filter by turning it counter-clockwise

and discard it.

4. Disconnect the return hose from the oil filter housing.

5. Remove the return hose fitting by:

6. Hold the fitting with a 1 1/16” wrench.

See Figure 7.13.

7. Back off the jam nut with a 1 1/4” wrench.

NOTE: Some models may have a NPTF fitting.

8. Remove the fitting.

9. Remove the oil filter housing using a large adjustable

wrench.

To install the oil filter housing:

1. Apply a small amount of Hydraulic thread sealant

such as Loctite® 569 to the threads of the tank nip

ple. See Figure 7.14.

NOTE: DO NOT use teflon tape on any fitting on a MTD

log splitter. Pieces of the tape can get into the sys

tem and damage the valve or the pump.

Figure 7.12

Drain pan

Hydraulic fluid under high pres-

sure can be dangerous. A high-

pressure hydraulic fluid leak or

spray can penetrate the skin. If this hap-

pens, seek immediate medical attention

to reduce the risk of blood poisoning,

which can lead to death or limb amputa-

tion.

Figure 7.13

Jam nut

Fitting

Figure 7.14

Hydraulic thread sealant

For Parts Call 606-678-9623 or 606-561-4983

www.mymowerparts.com

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 71 72

Kommentare zu diesen Handbüchern

Keine Kommentare

MTD 27-Ton Wartungshandbuch Seite 61

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Holzspalter MTD 27-Ton