MTD 27-Ton Wartungshandbuch PDF herunterladen (Seite 54)

2010 Log Splitters

12. Remove the log trays by removing screws that

attach them to the beam using a 1/2” wrench.

See Figure 6.8.

13. Pull on the locking pin and rotate it until it stays in

the unlocked position.

14. Move the beam to the vertical position.

15. Remove the cotter pin from the pivot pin.

See Figure 6.9.

16. Slide the pivot pin from the splitter.

17. Roll the tank assembly away from the beam.

To install the beam:

18. Follow the previous steps in reverse order.

NOTE: Tighten the six nuts and bolts of the wedge and retainer plates to a torque of 38 - 53 ft lbs (52 - 72 Nm).

NOTE: When tightening hoses with O-ring face fittings, hold the hose so that the center part of it does not

rotate against the O-ring while the swivel section is tightened. If the center part rotates, the O-ring can

be damaged and it will leak under pressure.

19. Test run the log splitter in a safe area before returning it to service.

Figure 6.8

Log tray

Figure 6.9

Pivot pin

Cotter pin

The beam weighs around 150 lbs.

Take measures to prevent the

beam from falling on the technician

while separating it from the tank.

! CAUTION! CAUTION

For Parts Call 606-678-9623 or 606-561-4983

www.mymowerparts.com

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 71 72

Keine Kommentare

MTD 27-Ton Wartungshandbuch Seite 54