MTD PS Spezifikationen PDF herunterladen (Seite 10)

J1, J2 IMAGER BOARD CONNECTORS

CCD Daughter Boards plug into these connectors. The daughter boards route the clock and bias traces from the timing

board to the proper pins of the CCD.

POWER SUPPLIES

An onboard switching supply provides all of the voltages necessary to operate the CCD Digital Reference Evaluation Board,

from a single +5V source.

Switching supplies can, however, be a source of low-level asynchronous noise. If asynchronous noise is present and

objectionable in an application, the internal switching supply can be disabled and external low-noise linear supplies can be

used to power the board. The procedure for configuring the board to accept external supplies is detailed Under Power

Supply Modes

J5 POWER CONNECTOR

The power connector is a 5-pin connector with +5V, +18V, -18V and two AGND connections. If the switching power supply

is used to generate the +15 and -10V supplies, then only an external +5V supply needs to be brought in through J5.

Otherwise, all three power supplies must be connected to the board via J5.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 55 56

Keine Kommentare

MTD PS Spezifikationen Seite 10