Mtd 241-521-000 Bedienungsanleitung PDF herunterladen (Seite 5)

ASSEMBLY INSTRUCTIONS

IMPORTANT: This unit has been shipped without

gasoiine or oil in the engine. After assembly, refer

to separate engine manual for proper fuel and

engine oil information.

Reservoir

•s

UNPACKING

Remove the log splitter parts from the carton by cut

ting the corners of the carton. Make certain all parts

and literature have been removed from the carton

before the carton is discarded.

All hardware for assembly of the log splitter has been

placed in position on the various parts.

■Parts in Carton (See figure 1)

Reservoir Tank Assembly

Engine and Pump Assembly (Bolted to bottom of

carton)

Tongue Assembly

Wedge, Beam and Cylinder Assembly

Hitch Assembly

Wheels

Tools Required for Assembly

(1) Rubber Mallet or Plastic Hammer

(2) 9/16" Wrenches*

(2) 1/2" Wrenches*

(1) Adjustable Wrench

(1) Screwdriver

*Ad]ustable Wrenches may be used.

Other Materials Required for Assembly:

Engine Oil

Unleaded Gasoline (regular grade gasoiine is an

acceptable substitute)

Approximately 4 Gallons of Dexron II Automatic

Transmission Fluid or 10W Non-Foaming Hydraulic

Fluid

INSTALLATION OF WHEELS

Attach the wheels to the reservoir tank assembly as

follows. See figure 2.

■5.

Pry off the hub caps and dust covers which are at

tached to the wheels. Discard the dust covers (us

ed for shipping only).

Remove one tapered roller bearing from inside

each wheel. See inset.

Remove the cotter pin, hex slotted nut and flat

washer from each axle. Place one wheel on each

axle, with the valve stem facing outward.

Pack the tapered roller bearings with wheel bear

ing grease, and place one on each axle.

Place one flat washer removed in step 2 on each

axle. Secure with hex slotted nut. Tighten sloted

nut until snug, then back off approximately 1 /3 turn

or until one of the slots on the slotted nut lines up

with the hole in the axle.

Check the assembly of the wheels. There should

be no side to side play, and the wheel should spin

freely.

Place hub caps in position on wheels and tap on

with a rubber mallet or plastic hammer.

1 2 3 4 5 6 7 8 9 10 ... 17 18

Kommentare zu diesen Handbüchern

Keine Kommentare

Mtd 241-521-000 Bedienungsanleitung Seite 5

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Werkzeug Mtd 241-521-000