MTD 737-0168 Betreibershandbuch PDF herunterladen (Seite 5)

SECTION2: ASSEMBLINGYOURSNOWTHROWER

NOTE: This Operator's Manual covers several models.

Snow thrower features vary by model. Not all

features discussed in this manual are applicable to all

snow thrower models.

LooseParts

The augers are secured to the auger shaft with two

shear pins and bow tie cotter pins. If you hit a

foreign object or ice jam, the snow thrower is

designed so that the pins may shear. Two

replacement shear pins and cotter pins are

provided for your convenience. See Figure 1. Store

these safely until needed.

Cotter

_L Shear Pins

Figure 1

IMPORTANT: NEVER replace the auger shear pins with

standard hex bolts. Any damage to the auger gearbox

or other components from using standard bolts will not

be covered by your snow thrower's warranty.

ItemsRequiredForAssembly

1. Pair of pliers

2. Engine oil

3. Fresh gasoline

BeforeAssembly

_, WARNING: Disconnect the spark plug wire

and ground it against the engine to prevent

unintended starting.

NOTE: Reference to the right hand or left hand side of

machine are observed from the operating position.

AssemblingHandle

• Remove the lower plastic wing nut, cupped washer

and carriage bolt from each side of the lower

handle. See Figure 2.

• Raise the upper handle assembly until it locks over

the lower handle.

• Look at the lower rear of the snow thrower frame to

be sure all the cables are aligned with the cable

roller guides. Make sure the spring (found at the

end of each cable) is attached to its actuator

bracket.

Upper Handle

Steering Cable

Tighten these

Wing

Lower Handle

Cable Tie_

_,Upper Shift Rod

Shift Rod

Con nector

Cupped

Washer

Wing

L_owerNut

Shift Rod

Carriage

Bolt

NOTE: Support Tubes are omitted from the illustration for clarity.

Figure 2

• Secure the upper handle and lower handle with the

two plastic wing nuts, cupped washers and carriage

bolts previously removed.

• Tighten the two wing nuts already in place on the

upper holes and secure the handles firmly.

• Slide the shift rod connector down over the end of

the lower shift rod. Tap the connector until it locks

over the lower shift rod. See Figure 2.

NOTE: If the connector is not properly assembled, the

shift rod will pivot and you will not be able to change

speeds or direction.

1 2 3 4 5 6 7 8 9 10 ... 30 31

Kommentare zu diesen Handbüchern

Keine Kommentare

MTD 737-0168 Betreibershandbuch Seite 5

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Schneewerfer MTD 737-0168