MTD 600 SERIES Betreibershandbuch PDF herunterladen (Seite 26)

Troubleshooting

Problem Cause

Remedy

Engine running erratically/

inconsistent RPM (hunting or

surging)

Excessive vibration

Unit fails to propel itself

Engine fails to start

1. Engine running on CHOKE.

2. Stale fuel.

3. Water or dirt in fuel system.

4. Carburetor out of adjustment.

5. Engine over-governed

1. Loose parts ordamaged auger.

1. Drive control cable in need of

adjustment.

2. Drive belt loose or damaged.

3. Friction wheel worn.

1. Move choke lever to RUN position.

2. Fill tank with clean, fresh gasoline.

3. Drain fuel tank. Refill with fresh fuel.

4. Contact an authorized Service Center.

5. Contact an authorized Service Center.

1. Stop engine immediately and disconnect spark

plug wire. Tighten all bolts and nuts. If vibration

continues, have unit serviced by an authorized

Service Center.

1. Adjust drive control cable. Refer to Maintenance &

Adjustments section.

2. Replace drive belt. Refer to Service section

3. Replace friction wheel. Refer to Service section.

ite i i

_ _ bj

Extension cord not connected 1. Connect one end of the extension cord to the

(when using electric start button, on electric starter outlet and the other end to a three-

models so equipped) prong 120-volt, grounded, AC outlet.

Chute does not stay stationary

while throwing snow using an

26 overhead chute control.

1. Insufficient preload applied to

chute control.

1. Refer to the Maintenance & Adjustments section to

adjust chute preload.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

MTD 600 SERIES Betreibershandbuch Seite 26

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Schneewerfer MTD 600 SERIES