MTD World Tiller - Series 240 Betreibershandbuch PDF herunterladen (Seite 12)

Maintenance&Adjustments

WARNING! Before inspecting, cleaning or servicing

the tiller, shut off the engine and wait for all moving

parts to come to a complete stop. Disconnect the

spark plug. Failure to follow these instructions

properly can result in serious personal injury or

property damage.

Maintenance

Engine

Refer to the Engine Operator's Manual packaged with your

machine for all engine maintenance.

Tines

Clean the underside of the tine shield after each use. The dirt

washes off the tines easier if rinsed off immediately instead of

after it dries. Always towel dry the tiller afterwards and apply a

light coat of oil or silicone to prevent rusting or water damage.

NOTE: Never use a pressure washer to clean the tiller. Water can

penetrate tight areas of the tiller and cause serious damage.

AirFilter

Service the air filter every 10 hours under normal operating

conditions. Clean every hour under extremely dusty conditions.

Poor engine performance and flooding usually indicates that the

air filter should be serviced. To service the air filter refer to the

separate Engine Operator's Manual.

Lubrication

Transmission

The transmission is pre-lubricated and sealed at the factory. It

requires no maintenance. See an authorized service dealer for

any service issues.

Tine Shafts

Remove tine assemblies and lubricate the tine shafts at least

once a season.

Wheel Shaft

Remove wheel assembly and lubricate the axle shaft at least

once a season.

Adjustments

TineWidth

The tilling width of the unit is 22 inches. Tilling width can

increase to 24 inches by removing the clevis and cotter pins,

sliding each outer tine out one inch, and securing in this position

with the pins. For cultivation, reduce the tine width to 13 inches

by removing the outer tines completely. See Fig. 6-1.

Cle

..ql==_22-inch_

..,4=_ 13-i nch ===========_

Figure 6-1

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

MTD World Tiller - Series 240 Betreibershandbuch Seite 12

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Mini-Bodenfräsen MTD World Tiller - Series 240