Mtd 24604C Bedienungsanleitung

1.00OWNER’S GUIDEOUTDOOR POWER EQUIPMENT for all seasonsSpringImportant:Read Safety Rules and Instructions Carefully3 H.P. EDGERModel Numbers246-60

MAINTENANCEAcWARNING {Disconnect the spark plug wire and ground against the engine before performing any adjustment, repairs or mainten

TROUBLE SHOOTING CHARTPROBLEM CAUSE (S)CORRECTIVE ACTION(S)1. Engine fails to start.A. Check fuel tank for gas.B. Spark plug lead wire disconnected.

Model 60412

Model 604PARTS LIST FOR MODEL 604 EDGERREF.NO.PARTNO.COLORCODEDESCRIPTIONNEWPARTREF.NO.PARTNO.COLORCODED£SCRIPTIONNEWPART1 720-0120 Black Grip45 781-0

MTD PRODUCTS INC ... VaRD-MaN COMPANYP.O. BOX 36900 • CLEVELAND OHIO 44136

INDEXSafe Operation Practices... 3Assembly Instructions...

AWARNINGtTo reduce the potential for any injury, comply with the following safety instructions. Failure to comply with the instructions may result in

NOTEThis unit is shipped WITHOUT GASOLINE or OIL. After assembly, see operating section of this manual for proper fuel and engine

HOLES IN AXLEFRONT AXLE HAIRPIN COTTERS (A)4.Starting on the right side of the edger, place the axle through the support arm on the fr

FIGURE 7HEX LOCK NUT (R)8. Assemble the throttle control to the handle panel as follows.A. Hold the throttle control assembly beneath the handl

16. Thread rod adjustment link (B) onto the upper clutch rod half, using about half of the threads. See figure 10.17. Thread the lo

BLADE PLANE ADJUSTMENTThe cutting blade can be adjusted to eight positions from vertical to horizontal. To adjust, release the adjustme

ACAUTIONRotating cutting blade may throw objects causing personal injury. Always wear safety glasses or some other suitable eye protect