MTD E600E Betreibershandbuch PDF herunterladen (Seite 17)

Figure 25

Changing Friction Wheel Rubber

The rubber on the friction wheel is subject to wear and

should be checked after 25 hours of operation, and

periodically thereafter. Replace the friction wheel

rubber if any signs of wear or cracking are found.

• Drain the gasoline from the snow thrower, or place

a piece of plastic under the gas cap.

• Tip the snow thrower up and forward, so that it

rests on the housing. See Figure 26.

Figure 26

• Remove six self-tapping screws from the frame

cover underneath the snow thrower.

• Remove the klick pins which secure the wheels,

and remove the wheels from the axle.

• Using a wrench to hold the shaft, loosen, but do not

completely remove, the hex nut and bell washer on

left end of gear shaft. See Figure 26.

• Lightly tap the hex nut to dislodge the ball bearing

from the right side of frame. Remove the hex nut

and bell washer from left end of shaft.

• Slide the gear shaft to the right and slide the friction

wheel assembly from the shaft.

• Remove the six screws from the friction wheel

assembly (three from each side). Remove the

friction wheel rubber from between the friction

wheel plate. See Figure 27.

Figure 27

• Reassemble new friction wheel rubber to the

friction wheel assembly, tightening the six screws

in rotation and with equal force.

• Position the friction wheel assembly up onto the pin

of the shift rod assembly, and slide the shaft

through the assembly. Reassemble in reverse

order.

SECTION 9: OFF-SEASON STORAGE

WARNING: Never store engine with fuel in

tank indoors or in enclosed, poorly ventilated

areas where fuel fumes may reach an open

flame, spark or pilot light as on a furnace,

water heater, clothes dryer, or other gas

appliance.

• If unit is to be stored over 30 days, prepare the

engine for storage as instructed in the separate

engine operator’s manual included with your unit.

• Remove all dirt from exterior of engine and

equipment.

• Follow lubrication recommendations in SECTION

7: MAINTAINING YOUR SNOW THROWER.

NOTE: When storing any type of power equipment in

an poorly ventilated or metal storage shed, care should

be taken to rustproof the equipment, especially springs,

cables and all moving parts.

Friction

Wheel

Disc

Stop

Bolt

Drive Belt

Friction Wheel

Support Bracket

Hex Nut and

Bell Washer

Friction Wheel

Plates

Screws

Friction Wheel

Rubber

Hub

Bearing

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

MTD E600E Betreibershandbuch Seite 17

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Schneewerfer MTD E600E