MTD 030 Series Betreibershandbuch PDF herunterladen (Seite 11)

Figure 3-4

Check to confirm that the blade control pivots freely

against the upper handle.

NOTE:The control cable is attached to the engine from the

factory. You will need to attach the free end of the cable to

the upper handle.

Control Cable

1. Unwrap the cable from the engine and route the cable

under the lower handle. Press the snap fitting into the hole

on the upper handle as shown in Fig. 3-5.

IMPORTANT:The cable must be routed properly to avoid contact

with all sharp edges and hot surfaces. Such contacts damage the

cable and render the controls inoperative.

1. Secure the cable to the lower left handle near the base of

the unit with a cable tie. See Fig. 3-6. Trim off any excess.

Figure 3-6

Wheels

NOTE: Use the hardware in Group 4 to complete the following

steps.

1. Place the mower on blocks up off of the ground.

2. Place the larger two wheels on the rear pivot arm axles and

secure with the flanged lock nuts. See Fig. 3-7.

Figure 3-5

2. Hook the "Z" end of the blade control cable into the blade

control from the outside to the inside. See Fig. 3-5.

Securingthe Cable

NOTE: Use the hardware in Group 3 to secure the blade control

cable.

Figure 3-7

3. Repeat with the two smaller wheels on the front pivot arm

axles. See Fig. 3-7.

4. Remove blocks and put the mower on ground.

SECTION3 -- ASSEMBLY& SET-UP 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Keine Kommentare

MTD 030 Series Betreibershandbuch Seite 11