Mtd 217-310-000 Bedienungsanleitung

$1.00CHAIN DRIVE TILLERModel Number 217-310-000IMPORTANT: Read Safety Rules and Instructions Carefully ^Thank you for purchasing an American-built pro

23. Place the depth bar (V) in position on the tailpiece.Secure with clevis pin (E) and hairpin cotter (F). ------See figure 19.Hairp n Cotter (F), 0

HOW TO USE YOUR TILLERThe tiller is a precision built machine designed for seed bed preparation, cultivating, furrowing and mulching. It is engi

In some soils, the desired depth is obtained tt e first time over the garden. In other soils, the d(!sired depth is obtained by going over the garden

CARBURETOR ADJUSTMENTAiwAR^G )If any adjustments are made to the engine while the engine is running (e.g. carburetor), disengage all clu

^ Self-Tappirg ScrewRemove Belt From Chain Case Pulley FirstFIGURE 26. FIGURE 28.2. After removing three screws, lift off belt cov< r. See figures

TROUBLE SHOOTING CHART, SYMPTOM POSSIBLE CAUSE(S) SOLUTIONEngine fails to start1. Check fuel tank for gas.1. Fill tank if empty.2. Spark plug lead wir

73С^5- ,,<7/ О Л- е-75'Г///''с7 --T-^JZ/S: „£, У(? crtr2z¿snv -V/jLS:i/y¿/ И-t-f^ ¡^P'^SKIOBlind BNIQNB.с jpíOTt^r/fí^^°

Model 310PARTS LIST FOR MODEL 310 TILLEREF.to.PARTNO.COLORCODEDESCRIPTIONNEWPARTREF.NO.PARTNO.COLORCODEDESCRIPTIONNEWPART1720-0204Grip26 738-0318Shoul

Model 310TINE CHARTPart No.Description784-0092784-0094784-0091784-0093Inner Tine Ass’y. Comp—R.H. Outer Tine Ass’y- Comp.—R.H. Inner Tine Ass’y.

Model 310Chain Case Assembly 784-0103REF.NO.PARTNO.COLORCODEDESCRIPTIONNEWPARTREF.NO.PARTNO.COLORCODEDESCRIPTIONNEWPART1710-0513Hex L-Scr. 1/4-28 x .6

INDEXSafe Operation Practices... 3Assembly Instructions... 4Operation...

PARTS INFORMATIONPOWER EQUIPMENT PARTS AND SERVICEParts and service are available through the authorized service firms listed below. All orders sho

Ac WARNING \To reduce the potential for any injury, comply with the foliowing safety instructions. Faiiure to comply with the instructions may resuit

NOTEReference to left or right side of the tiller is determined from behind the unit in the operating position.ASSEMBLY INSTRUCTIONSNOTEFI

Tailpiece4. Secure the tailpiece to the rear frame rails with two hex bolts (D), lock washers (B) and hex nutx (C). See figure 4. Tighten all four he

37. Remove the clevis pin and hairpin cotter from the — inner tine assemblies as shown in figure 7. Place the right and left hand tine assemblies in

11. Place the handle panel (AB) in position on the handles. Secure the upper holes in the panel to the handles with carriage bolts (A), lock

A Bc y ^FIGURE 13.16. Assemble the throttle control to the handle panel as follows.A. Hold the throttle control assembly beneath the handle panel. T

19. Hook the “Z” end of clutch cable wire into clutch grip. See figure 16.Hold the clutch grip so that the grip is down against the handle. Adjust th