Mtd TMO-33849A Bedienungsanleitung PDF herunterladen (Seite 5)

HEX BOLT (U)

LOCKWASHER (S)

ASSEMBLY INSTRUCTIONS

1. Remove the snow thrower, all loose parts and

hardware package from the carton.

2. Tip the snow thrower forward, so that the augers

are face down.

■ 3. Assemble the linkage arms (Ref. AE & AF) to the

housing assembly as shown in figure 4. Be sure

the linkage arms have the large notch up. Secure

with four hex bolts (U) 1/2-13 x 1.25" Lg., four

hex nuts (T) and lockwashers (S) provided.

FIGURE 4

HELPER bPRING (Z)

4. Place helper spring (Z) in position on linkage arm

assemblies. Secure with flat washers (W) and hex

bolts (V) provided in hardware pack. See figure

5. Thread bolt approximately one inch into the

spring insert. Adjustment is made in step number

26.

Tip the snow thrower back in normal position so

that is rests on linkage arms.

FIGURES

DRIFT

CUTTER

CARRIAGE BOLT

(H)

LOCK WASHER (I)

HEX NUT (J)

Assemble the drift cutters (AH) to the snow

thrower housing with four carriage bolts (H),

lockwashers (I) and hex nuts (J). See figure 6.

Heads of carriage bolts assemble from the inside

of housing.

FIGURES

1 2 3 4 5 6 7 8 9 10 ... 19 20

Keine Kommentare

Mtd TMO-33849A Bedienungsanleitung Seite 5