Mtd 230 FR Bedienungsanleitung PDF herunterladen (Seite 10)

WARNING: Disconnect the spark plug

wire and ground it against the engine

to prevent unintended starting.

WARNING: NEVER attempt to make

any adjustments while the engine is

running, except where specified in the

operator’s manual.

Shave Plate

1. To check the adjustment of the shave plate, place the

unit on a level surface. The wheels, shave plate and

augers should all contact level surface. Note that if the

shave plate is adjusted too high, snow may blow under

the housing. If the shave plate wears out excessively,

or the unit does not self-propel, the shave plate may

be too low and needs to be adjusted.

NOTE: On new units or units with a new shave plate

installed, the augers may be slightly off the ground.

2. To adjust, tip the snow thrower back so that it rests

on the handle. Loosen the lock nuts and bolts which

secure the shave plate to the housing. See Figure 7.

Move the shave plate to desired position and retighten

the nuts and bolts securely.

Replacing Shave Plate

The shave plate is attached to the bottom of the auger

housing and is subject to wear. It should be checked

periodically. There are two wearing edges and the shave

plate can be reversed. Refer to Figure 7.

1. Remove the carriage bolts and hex lock nuts which

attach it to the snow thrower housing.

2. Install new shave plate, making sure the heads of the

carriage bolts are on the inside of the housing.

3. Adjust the shave plate according to instructions

above. Tighten the nuts securely before operating the

snow thrower.

NOTE: For information regarding the price and availability

of Shave Plate Kit refer to customer support on page 2.

Control Cable

As a result of both the control cable and the drive belt

stretching due to wear, periodic adjustments may be

necessary.

If the auger seems to hesitate when rotating while the

engine maintains a constant speed, an adjustment is

necessary. Proceed as follows:

The upper hole in the control handle provides for an

adjustment in cable tension. To adjust, disconnect the

end of control cable from the bottom hole in the control

handle and reinsert it in the upper hole. Insert the cable

from the outside as shown in Figure 8. Test the snow

thrower to see if there is a noticeable difference.

Carburetor

WARNING: If any adjustments need to

be made to the engine while the engine

is running (e.g. carburetor), keep

clear of all moving parts. Be careful of

muffler, engine and other surrounding

heated surfaces.

1. Refer to the separate engine manual, packed with

your unit, for carburetor adjustment information.

Adjustments

Maintenance

Figure 7

Disconnect the

spark plug wire

and ground it against

the engine to prevent

unintended starting.

NEVER attempt to

make any adjust-

ments while

the engine is run-

ning, except where

specified in

the operator’s

manual.

Before servicing,

repairing, or inspect-

ing, disengage the

control bail and

stop engine. Wait

until all moving

parts have come to a

complete stop.

WARNING

Figure 8

Side View

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

Mtd 230 FR Bedienungsanleitung Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Autos Mtd 230 FR