Mtd 240-650-000 Bedienungsanleitung

J$1.00OWNER'S GUIDEASSEMBLY « OPERATION • MAINTENANCE • PARTS5 H.R SHREDDERModel Numbers240-650-000240650Important: Read Safety Rules and Instruc

When reassembling the blade, tighten to between 375 and 450 inch pounds, or lacking torque wrench, tighten securely.FLAILS AND FINGERSThe flai

TROUBLE SHOOTING CHART1 SYMPTONPOSSIBLE CAUSE(S)SOLUTIONEngine fails to start 1. Check fuel tank for gas.1. Fill tank if empty.2. Spark plug lead wire

Model 6504 5pLMaT iiu&STiT0TeJ> 5L 7/6'0‘?5*> :Boa-i Vifc'iixi^HeKti TC> T^£. Q0TS\b£.;a 'tiMs pRou, lO'i^ 110&apos

Model 650PART LIST FOR MODEL 550 SH REDDER.Ref. PartColor New Ref. PartColorNewMo. No. CodePartNo. No.CodePart111476Door Chip It33 11459A Flail2710-04

REPLACEMENT PARTS • P.O. EOX 360900 • CLEVELAND, OHIO 44136

INDEXRules for Safe Operation... 3Assembly . . . ...

AcWARNING♦♦To reduce the potential for any injury, comply with the following safety instructions. Failure to comply with the instructions

NOTEThis unit is shipped WITHOUT GASOLINE or OIL. After assembly, see separate engine manual for proper fuel and engine oil recommendations.ASSEM

INSTALLATION OF HOPPER AND UPPER LEAF RAMP1.Lower Leaf Ramp SectionThe lower leaf ramp section on the shredder is placed in an upright pos

ATTACHING THE CATCHER BAGYour unit is equipped with a nylon bag which attaches to the discharge opening. If desired, place the end of the ba

TO STOP ENGINE1. Move throttle control lever to OFF position.2. Disconnect spark plug wire from spark plug and ground against the engine

To place in this position, hold the edge of the leaf ramp, pull up on the release bar and gently lower the leaf ramp to the ground. See figures 11 and

MAINTENANCE▲c WARNING IDisconnect spark plug wire and ground it against the engine before performing any repairs or maintenance.ENGINERefer